User Manual

USER MANUAL
9
2. WIFI NETWORK SELECTION
This submenu offers a list of available networks. Select the network and confirm by pressing
MENU. If the network is secured, it is necessary to enter the password. Use the arrows to select
each character of the password and press MENU to move to the next character and confirm the
password.
3. NETWORK CONFIGURATION
Normally, the network is configured automatically. The user may also conduct it manually using
the following parameters of this submenu: DHCP, IP address, Subnet mask, Gate address, DNS
address and MAC address.
4. SCREEN SETTINGS
The parameters available in this submenu enable the user to customize the main screen view.
The user may also adjust the display contrast as well as the screen brightness. The screen
blanking function enables the user to adjust the brightness of a blank screen. Screen blanking
time defines the time of inactivity after which the screen goes blank.
5. LANGUAGE
This function is used to select the language version of the controller menu.
6. FACTORY SETTINGS
This function is used to restore factory settings of the controller.
7. SOFTWARE UPDATE
The function automatically detects and downloads the latest software version when available.
8. SERVICE MENU
The parameters available in the service menu should be configured only by qualified fitters and
access to this menu is secured with a code.
9. SOFTWARE VERSION
This function is used to view the controller software version.