User Manual

USER MANUAL

IV. FIRST START-UP

In order for the controller to work properly, follow these steps while starting it for the first time:

1. Connect EU-WiFi RS to the main controller using an RS cable.

2. Connect the power supply to the module.

3. Go to the module menu and select WiFi network selection. A list of available WiFi networks

will appear - connect to one of the networks by entering the password. In order to enter

the password, use the arrows and select the right characters. Press the Menu button to

confirm.

4. In the main controller menu go to Fitter’s menu → Internet module → ON and Fitter’s

menu → Internet module →DHCP.

NOTE

It is advisable to check if the internet module and the main controller have the same IP

address (in the module: Menu → Network configuration → IP address; in the main

controller: Fitter’s menu → Internet module → IP address). If the address is the same

(e.g. 192.168.1.110), the communication between the devices is correct.

Required network settings

For the Internet module to work properly, it is necessary to connect the module to the network

with a DHCP server and an open port 2000.

After connecting the Internet module to the network, go to the module settings menu (in the

master controller).

If the network does not have a DHCP server, the Internet module should be configured by its

administrator by entering appropriate parameters (DHCP, IP address, Gateway address, Subnet

mask, DNS address).

1. Go to the Internet module settings menu.

2. Select "ON".

3. Check if the "DHCP" option is selected.

4. Go to "WIFI network selection"

5. Select your WIFI network and enter the password.

6. Wait for a while (approx. 1 min) and check if an IP address has been assigned. Go to the "IP

address" tab and check if the value is different from 0.0.0.0 / -.-.-.-.

a) If the value is still 0.0.0.0 / -.-.-.-.- , check the network settings or the Ethernet

connection between the Internet module and the device.

7. After the IP address has been assigned, start the module registration in order to generate a

code which must be assigned to the account in the application.

V. CONTROLLING THE SYSTEM ONLINE

Once the devices have been connected properly, generate the registration code. In the module

menu select Registration or in the main controller menu go to: Fitter’s menu → Internet module

→Registration. After a while the code will appear on the screen. Enter the code in the application

or at

https://emodul.eu.