Tus neeg siv phau ntawv

2. ADVANCED SETTINGS

It is possible to connect many repeaters in a chain. In order to register another repeater, follow these steps:

1. Connect the first RP-4 to the power supply socket.

2. Press the registration button on the first RP-4 – the control lights are flashing clockwise.

3. Press the registration button on the transmitting device (EU-C-8r room sensor or room regulator etc.)

4. Once steps 2 and 3 have been performed properly, the device animation will change - the control lights will start

flashing anti-clockwise.

5. Connect the second RP-4 to the power supply socket.

6. Press the registration button on the second RP-4 – the control lights are flashing clockwise.

7. Once steps 5 and 6 have been performed properly, the second device animation will change after a few seconds -

the control lights will start flashing anti-clockwise, and the control lights on the first RP-4 will be flashing

simultaneously for 5 seconds.

8. Start the registration process on the receiving device (e.g. external controller/Wi-Fi 8s / ST-2807 / ST-8s etc.)

9. If the registration has been successful, the receiving controller will display an appropriate message to confirm and

all the control lights on the second RP-4 will be flashing simultaneously for 5 seconds.

In order to register another device, follow the same steps.

NOTE

In the case of battery-powered devices, it is not advisable to create chains consisting of more than two

repeaters.

IV. TECHNICAL DATA

Specification

Value

Supply voltage

230V +/-10% / 50Hz

Operation temperature

5°C - 50°C

Maximum power consumption

Frequency

868MHz

Max. transmit power

25mW