Tus neeg siv phau ntawv

III. HOW TO USE THE DEVICE

1. REGISTRATION

In order to register devices in one repeater, follow these steps:

1. Connect RP-4 to the power supply socket.

2. Press the registration button on RP-4 – the control lights are flashing clockwise.

3. Press the registration button on the transmitting device (EU-C-8r room sensor or room regulator etc.)

4. Once steps 2 and 3 have been performed properly, the device animation will change - the control lights will start

flashing anti-clockwise.

5. Start the registration process on the receiving device (e.g. external controller/Wi-Fi 8s / ST-2807 / ST-8s etc.)

6. If the registration has been successful, the receiving controller will display an appropriate message to confirm

and all the control lights on RP-4 will be flashing simultaneously for 5 seconds.

NOTE

If all control lights start flashing very fast after the registration has been started, it means that the device memory

is full (30 devices have already been registered).

NOTE

It is possible to cancel the registration process at any time by pressing Cancel button and holding it for 5

seconds.

In order to restore factory settings, disconnect the device from the power supply. Next, holding the button,

connect the device to the power supply and wait until an intermittent light signal appears (two control lights

start flashing). Next, release the button and press it again (four control lights start flashing). Factory settings

have been restored, all control lights go on at the same time.

NOTE

In order to cancel restoring the factory settings, press Cancel button.

NOTE

Remember to pair with the repeater only those devices which have a signal problem. The range may get worse

if you register devices that do not require a better signal.