Phau Ntawv Qhia

Description
EU-C-2N sensor is intended to be installed on the windows of particular
heating zones. When the window is opened, the sensor sends the
information to the main controller which deactivates heating in the zone
after a pre-set delay time.
Technical data
Power supply...........................................................batterie ER14250
Operation temperature...........................................................5-50°C
Operation frequency.............................................................868 MHz
Ambient humidity...................................................................5-85%
Installation
In order to install EU-C-2 sensor, place double-sided tape on the upper
part of the window frame (not where the hinges are located) and stick
the back of the sensor to the tape. Next, put the front part of the sensor
in its place. The installation method is illustrated in the picture below.
NOTE
The magnet should be placed on the window casement!
Maximum distance between the sensor and magnet up to 15 mm.
Sensor registration
Once ‘Registration’ function in the
main controller has been activated,
press quickly the communication
button on a given EU-C-2N sensor.
If the registration attempt has been
successful, the main controller will
display an appropriate message
and the control light on EU-C-2N
sensor will  ash twice.
If the control light goes on
permanently, there is no
communication with the main
controller.
1. adhesive labels
1. casing
2. antenna
3. battery
4. montage axle, position of the sensor relative to the magnet
5. registration button
6. casing
7. magnet
EU Declaration of Conformity
Hereby, we declare under our sole responsibility that EU-C-2N
manufactured by TECH STEROWNIKI, head-quartered in Wieprz Biała
Droga 31, 34-122 Wieprz, is compliant with Directive 2014/53/EU of
the European parliament and of the Council of 16 April 2014 on the
harmonisation of the laws of the Member States relating to the making
available on the market of radio equipment, Directive 2009/125/EC
establishing a framework for the setting of ecodesign requirements for
energy-related products as well as the regulation by the MINISTRY OF
ENTREPRENEURSHIP AND TECHNOLOGY of 24 June 2019 amending the
regulation concerning the essential requirements as regards the restriction
of the use of certain hazardous substances in electrical and electronic
equipment, implementing provisions of Directive (EU) 2017/2102 of the
European Parliament and of the Council of 15 November 2017 amending
Directive 2011/65/EU on the restriction of the use of certain hazardous
substances in electrical and electronic equipment (OJ L 305, 21.11.2017,
p. 8).
For compliance assessment, harmonized standards were used:
PN-EN IEC 60730-2-9 :2019-06 art. 3.1a Safety of use
PN-EN 62479:2011 art. 3.1 a Safety of use
ETSI EN 301 489-1 V2.2.3 (2019-11) art.3.1b Electromagnetic
compatibility
ETSI EN 301 489-3 V2.1.1:2019-03 art.3.1 b Electromagnetic
compatibility
ETSI EN 300 220-2 V3.2.1 (2018-06) art.3.2 Eective and coherent use
of radio spectrum
ETSI EN 300 220-1 V3.1.1 (2017-02) art.3.2 Eective and coherent use
of radio spectrum
Wieprz, 20.11.2020