User's Manual

3/5
key is at “ON” position, press transmitter button 1, doors lock. Press transmitter button 2, doors unlock.
When entering valet-parking (OVERRIDE) feature setup, press transmitter’s button 1, indicator (parking)
lights will blink once to indicate doors locking. Press transmitter’s button 2, indicator (parking) lights will
blink twice to indicate doors unlocking.
13. Self Diagnostics (Door or Trunk not been closed properly):
When entering arming mode, siren will wail once and indicator (parking) lights will blink once. System
will automatically detect all points, including doors, hood and trunk. When door、hood defective points is
not functioning normally, after 2 seconds siren wails 4 times and lights blink 4 times. When other
detective point is functioning abnormally, siren wails 5 times and lights blink 5 times immediately. System
began to detect when defective points are resumed.
14. Auto By-Pass:
The system automatically by-passes detective points which are not working normally while the remaining
points are still executing until defective points are repaired.
15. Enters into Valet-Parking (OVERRIDE) Feature Setup:
In case of a valet-parking situation and needing to temporarily disable anti-theft feature, you can turn car
key to “ON” position and press valet/override switch once till siren wail and indicator(parking) light blink
once, and anti-theft status indicator, LED, will steady “ON” to indicate the entering of override feature
setup. Under this mode, system’s anti-theft feature will be disabled then only have capability to remote
Central Door Locks. One more time, turning car key from “OFF” to “ON” position and press the
valet/override switch once again till siren wail and indicator (parking) lights blink 3 times, LED
distinguished to indicate that the override feature is disabled and alarm’s anti-theft feature is resumed.
REMARK: System will quit valet-parking (override) mode automatically after key OFF/ON 10 times.
16. Entering Emergency Override(VALET)mode
：
When remote control is not functioning and wanting to disable and anti-theft feature, turn car key to “ON”
position and press the valet/override switch once. Siren wail and and indicator (parking) light blink once,
and anti-theft status indicator, LED will steady on to indicator entering of the emergency override feature
setup. At this time, system’s anti-theft feature and killer will be disabled. One more time, turning car key
from “OFF” to “ON” position and press the valet/override switch once again, siren wail and
parking(indicator) lights blink 3 times, or key on/off for 10 times, siren wails 3 times and indicator light
blinks 3 times, LED off which means VALET mode is disable and alarm’s anti-theft feature is resumed.
17. Tamper alert with memory & LED indication:
If the alarm system has been tempered under arming mode, when you disarming the system, siren wails
3 times, indicator (parking) lights blink 3 times. Meanwhile the anti-theft indicator, LED, will change
indication and memorize records automatically as follow,
STATUS LED INDICATION EXPLANATION
Door/Hood triggered
Blinks 4 times, stop,
then blinks 4 times
Door/Hood been opened during arming mode.
Turn the car key to “ON” position, LED indicator is
reset.
Shock sensor triggered
Blinks 5 times, stop,
then blinks 5 times
System been touched lightly during arming mode.
Turn the car key to “ON” position, LED indicator is
reset.
Armed Blinks slowly System is armed and your car is under protection
Disarmed Stop blinks
System is disarmed with no triggering during arming
mode.
Enter code learning
mode
Flash rapidly System being in code-learning or renewing mode.
Valet/Override mode Steady on System being in valet (override) mode.