Safety Data Sheets (SDS)

Page 2 of 6
TEC ULTIMATE PRE-MIXED
MORTAR
Print Date: 03-16-2015 836906PM
SAFETY DATA SHEET
______________________________________________________________________________
*This product contains one or more materials that may be hazardous when present as an airborne dust. During
normal handling of the product, the material is encapsulated within the product and will not present an exposure
risk. Once the product has reached its final state and is abraded or disturbed, dusting and exposure may occur.
Unlisted ingredients are not 'hazardous' per the Occupational Safety and Health Administration Hazard
Communication Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous
Materials Information System ingredient disclosure list. See Section 8 for exposure limit guidelines.
SECTION 4: FIRST AID MEASURES
IF IN EYES: Use an eye wash to remove a chemical from your eye regardless of the level of hazard. Flush the
affected eye for at least twenty minutes. Tilt the head to prevent chemical from transferring to the uncontaminated
eye. Seek medical advice after flushing.
IF ON SKIN: Wash with soap and water. Get medical attention if irritation develops or persists.
IF INHALED: Remove to fresh air. Call a physician if symptoms persist.
IF SWALLOWED: Minimal risk of harm if swallowed. Do not induce vomiting. Seek medical attention
immediately. Do not give anything by mouth to an unconscious person.
SECTION 5: FIRE FIGHTING MEASURES
EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide.
UNUSUAL FIRE AND EXPLOSION HAZARDS: There is a possibility of pressure buildup in closed containers
when heated. Water spray may be used to cool the containers.
SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear self-
contained breathing apparatus and full protective equipment.
HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide Metal fumes
SECTION 6: ACCIDENTAL RELEASE MEASURES
SPECIAL PROTECTION: No adverse health effects expected from the clean-up of spilled material.
Follow personal protective equipment recommendations found in
Section 8 of this MSDS.
METHODS FOR CLEAN-UP: Dike if necessary, contain spill with inert absorbent and transfer to
containers for disposal. Keep spilled product out of sewers, watersheds,
or water systems.
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
SECTION 7: HANDLING AND STORAGE
Handling: No special handling instructions due to toxicity.
Keep away from heat, sparks and flame.
Wash thoroughly after handling.
Keep container closed.
Emptied container retains vapor and product residue.
Observe all labeled precautions until container is cleaned.
Drums of this material should be grounded when pouring.
DO NOT CUT OR WELD ON OR NEAR THIS CONTAINER.
Storage: Store in a cool, dry place.Protect from freezing