Safety Data Sheets (SDS)
Page 2 of 2
06-03-2015
805211PM
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 4: FIRST AID MEASURES
IF IN EYES: None expected to be needed, however, use an eye wash to remove a chemical from your eye
regardless of the level of hazard.
IF ON SKIN: Wash with soap and water.
IF VAPORS INHALED: Remove to fresh air. Call a physician if symptoms persist.
IF SWALLOWED: Do not induce vomiting. Seek medical attention if symptoms develop. Provide medical care
provider with this MSDS. Induced vomiting may lead to aspiration of the material into the lungs potentially causing
chemical pneumonitis that may be fatal.
SECTION 5: FIRE FIGHTING MEASURES
FLASH POINT: Non flammable
AUTOIGNITION TEMPERATURE: Not established
LOWER EXPLOSIVE LIMIT (% in air): Not established
UPPER EXPLOSIVE LIMIT (% in air): Not established
EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide.
UNUSUAL FIRE AND EXPLOSION HAZARDS: There is a possibility of pressure buildup in closed containers
when heated. Water spray may be used to cool the containers.
SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear self-
contained breathing apparatus and full protective equipment.
HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide Chlorine containing gases
SECTION 6: ACCIDENTAL RELEASE MEASURES
SPECIAL PROTECTION:
No adverse health effects expected from the clean-up of spilled material.
Follow personal protective equipment recommendations found in Section 8
of this MSDS.
CLEAN-UP: Dike if necessary, contain spill with inert absorbent and transfer to containers
for disposal. Keep spilled product out of sewers, watersheds, or water
systems.
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
SECTION 7: HANDLING AND STORAGE
Handling: No special handling instructions due to toxicity.
Storage: Store in a cool, dry place.Protect from freezing
Consult the Technical Data Sheet for specific storage instructions.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
EYE PROTECTION: Wear safety glasses when handling this product.
SKIN PROTECTION: Not normally considered a skin hazard. Where use can result in skin
contact, practice good personal hygiene. Wash hands and other
exposed areas with mild soap and water before eating, drinking, and
when leaving work.
GLOVES: Not normally required. Use nitrile gloves if conditions warrant.
RESPIRATORY PROTECTION: Respiratory protection may be required to avoid overexposure when
handling this product. Use a respirator if general room ventilation is
not available or sufficient to eliminate symptoms.
Respirators should be selected by and used following requirements
found in OSHA's respirator standard (29 CFR 1910.134).