SDS

Page 2 of 7
ACLR GROUT SAND - COFFEE
Print Date: 06-03-2015 839312PM
SAFETY DATA SHEET
______________________________________________________________________________
SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS
Chemical Name CAS # PERCENT Classification Note
Crystalline silica 14808-60-7 50 - 70 Carc. 1A; H350
STOT RE 1; H372
* (see below)
Portland cement 65997-15-1 10 - 30 STOT SE 3; H335 * (see below)
Calcium oxide, CaO 1305-78-8 1 - 5 Acute Tox. 4; H302
Eye Dam. 1; H318
Skin Irrit. 2; H315
STOT SE 3; H335
* (see below)
Titanium dioxide 13463-67-7 0.1 - 1 Carc. 2; H351 * (see below)
Unlisted ingredients are not 'hazardous' per the Occupational Safety and Health Administration Hazard
Communication Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous
Materials Information System ingredient disclosure list. See Section 8 for exposure limit guidelines.
SECTION 4: FIRST AID MEASURES
IF IN EYES: Flush eyes with plenty of water for at least 20 minutes retracting eyelids often. Tilt the head to
prevent chemical from transferring to the uncontaminated eye. Get immediate medical attention.
IF ON SKIN: Wash with soap and water. Remove contaminated clothing and launder. Get medical attention if
irritation develops or persists.
IF INHALED: Remove to fresh air. Restore breathing, if necessary. Call a physician if symptoms persist.
IF SWALLOWED: Severely irritating. Do not induce vomiting. Seek medical attention immediately. Drink 2
glasses of water or milk to dilute. Do not give anything by mouth to an unconscious person.
SECTION 5: FIRE FIGHTING MEASURES
EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Material will not burn.
SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear self-
contained breathing apparatus and full protective equipment.
HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide Aluminum oxide Sulfur
containing gases
SECTION 6: ACCIDENTAL RELEASE MEASURES
SPECIAL PROTECTION: Exposure to the spilled material may be irritating or harmful. Follow
personal protective equipment recommendations found in Section 8 of
this MSDS. Additional precautions may be necessary based on special
circumstances created by the spill including; the material spilled, the
quantity of the spill, the area in which the spill occurred.
METHODS FOR CLEAN-UP: Avoid creating dusts. Eliminate ignition sources. If a vacuum is used,
ensure that the material is wetted or otherwise treated so an explosive
dust atmosphere is not created within the vacuum.
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300