Technical Specifications

Page 3 of 6
TEC 749 RELEASE PRESS SENS AD
Print Date: 04-10-2019
828421PM
SAFETY DATA SHEET
______________________________________________________________________________
SKIN PROTECTION:
Not normally considered a skin hazard. Where use can result in skin
contact, practice good personal hygiene. Wash hands and other
exposed areas with mild soap and water before eating, drinking, and
when leaving work.
GLOVES:
Not normally required. Use nitrile gloves if conditions warrant.
RESPIRATORY PROTECTION:
No respiratory protection required under normal conditions of use.
Respirators should be selected by and used following requirements
found in OSHA's respirator standard (29 CFR 1910.134).
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE:
Semi-solid
COLOR:
Off-white
ODOR:
Characteristic Slight
ODOR THRESHOLD:
Not established
pH:
7.6
FREEZING/MELTING POINT (deg. C):
Not established
BOILING POINT (deg. C):
Not established
FLASH POINT:
Non flammable
EVAPORATION RATE:
Not established
FLAMMABILITY:
Not a flammable solid or gas
UPPER EXPLOSIVE LIMIT (% in air):
Not established
LOWER EXPLOSIVE LIMIT (% in air):
Not established
VAPOR PRESSURE (mm Hg):
Not established
VAPOR DENSITY:
Not established
WEIGHT PER GALLON (lbs.):
8.35
SPECIFIC GRAVITY:
1.010
SOLUBILITY:
Not established
OCTANOL/WATER COEFFICIENT:
Not established
AUTOIGNITION TEMPERATURE:
Not established
DECOMPOSITION TEMPERATURE:
Not established
VISCOSITY:
No data available.
SOLIDS (% by weight):
53.5
VOC, weight percent
0.00
SECTION 10: STABILITY AND REACTIVITY
STABILITY:
Stable under normal conditions.
CHEMICAL INCOMPATIBILITY:
Not established
HAZARDOUS POLYMERIZATION:
Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS:
Aldehydes Carbon monoxide, carbon dioxide
Nitrogen containing gases
SECTION 11: TOXICOLOGICAL INFORMATION
Component Toxicity / Toxicology Data:
COMPONENT NAME
LD50/LC50
Rosin ester
Oral LD50 Rat > 2,000 mg/kg
This product is a mixture. Unless noted, the information below is based on components.
Skin corrosion / irritation: No irritation hazard in normal industrial use.