Operation Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
12 TEAM SIS 14 - 101117
Assembly page 12/24
Fax [phone]
release the button. To stop the steam, slide the locking button of the continuous steam
button forwards.
 When ironing, the pilot light of the iron will go on and off from time to time. This means that
the temperature of the iron is regulated by its thermostat. You can continue ironing.
 When you use a lot of steam in a very short time, the steam output is lightly reduced until
your appliance produces enough steam to reduce the difference. This phenomenon also
happens when there isn’t enough water in the water tank.
 When the water tank is running empty, you will hear more noise when pressing the steam
button, the empty water tank indicator will flash in red and beeps will sound. The
appliance switches off automatically. If you want to go on using the steam function, you
will have to refill the water tank.
Notes:
- When you start using the steam function, it is normal that the electrical pump makes some
vibrating sounds. This is due to the air inside the anti-calc cartridge and will lessen when the air
has been pumped out. If the noise has not diminished after 60 seconds, check if the water tank
and the cartridge have been assembled correctly.
- If you remove the water tank when the appliance is switched on, the empty water tank
indicator will flash in red, beeps will sound and the appliance will switch off automatically.
When the water tank is put back in place, the ON/OFF switch will light again and the
appliance will be ready for use again.
STEAMING IN A VERTICAL POSITION
You have to hang the cloth you want to smooth out avoiding the creases and place the iron in
a vertical position at a few centimetres from the piece of cloth. Then move the iron and press
the burst of steam button at the same time.
DRY IRONING
For ironing without steam, do not press the burst of steam button.
AUTOMATIC SHUT-OFF
When the iron has not been moved for 15 minutes, the appliance will shut off automatically
and beeps will sound. The power switch will blink.
Press the power switch if you want to restart the appliance.
WHEN FINISHED IRONING
 Unplug the appliance and let it cool down.
 It is not necessary to empty the water tank.
 We recommend placing the iron on its base when you store it. The therefore foreseen
place is non-slip and will not damage the soleplate of the iron.
ANTI-SCALE CARTRIDGE
 Your appliance is equipped with an anti-calc cartridge located inside the water tank. As a
result, you can use tap water as it will be filtered by the cartridge.
 It is necessary to replace the cartridge approximately every 2 or 3 months. However this
period may vary depending on the frequency of use and of the scale content of the
water in your area. If the water contains much scale, you will have to replace the
cartridge more frequently. You can delay the replacement of the cartridge by using
distilled water or a mixture of 50% tap water and 50% distilled water.