Operation Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
10 TEAM SIS 14 - 101117
Assembly page 10/24
Fax [phone]
 Proceed the same way if the water tank stops working or is damaged. To avoid the risk of
electric shock, do not disassemble the iron or steam tank, take it to a qualified technician
for examination and repair. Incorrect re-assembly can cause a risk of electric shock when
the iron or steam tank is used.
 Fully unwind the main cord and supply hose before starting to iron.
 The steam tank switch should always be turned to “0” before plugging or unplugging the
power cord from outlet.
 Unplug the appliance and allow the iron and the water tank to cool down before
cleaning or storing them and for pressurized steam iron station (depending on the model)
before opening, filling or emptying the water tank.
(*) Competent qualified service: after-sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this service.
STEAM IRON: PRECAUTION OF USE AND TEMPERATURES
 Always check first if a label with ironing instructions is attached to the article to be ironed.
Follow these ironing instructions in all cases.
 If ironing instructions are missing but you know the kind of fabric, then see the table for
recommended ironing temperatures.
 When you plug in the appliance, a beep will sound and the ON/OFF button will start
flashing to indicate that the appliance is connected to the mains. To switch on the
appliance, press the ON/OFF switch ; one beep will sound and the ON/OFF button will
remain lighted. The button for high steam output will start flashing and after a few seconds
it will remain lighted, indicating that the steam function is available.
 Set the temperature dial of the iron to the desired position. The pilot light of the iron will
come on, indicating that the iron is heating. As soon as the desired temperature is
reached, the pilot light will go out and you can start ironing.
 During ironing this pilot light will come on from time to time. When this happens, the
soleplate is being heated up to the required temperature again. You can continue
ironing.
 The table is valid for the fibre materials only. If some kind of finish has been applied (gloss,
wrinkle, relief etc.), the textile can best be ironed at a lower temperature.
Kind of textile
Temperature dial
Steam ironing
Nylon
Synthetic (e.g. acetate,
acrylic, viscose,
polyamide, polyester…)
Silk
MIN



NO
Wool



YES
Cotton
Linen



MAX
YES