Operation Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
13 TEAM SFC 2 - 100622
Assembly page 13/40
Fax [phone]
RECOMMENDED MAY CAUSE THE BUILD-UP OF A PALE RESIDUE. THIS RESIDUE CAN BE REMOVED
BY USING A DECALCIFYING PRODUCT OR WITH A FEW DROPS OF VINEGAR (SEE
TROUBLESHOOTING GUIDE).
10) When the steamer stops emitting steam, after approximately 15 minutes of use, unplug the
appliance, remove the water tank, refill, put it back in the appliance and continue
cleaning.
WARNING: NEVER RUN THE STEAMER WITHOUT WATER. NEVER DIRECT STEAM AT ANY PERSON OR
ANIMAL. USE THE STEAMER ON SEALED HARD FLOORS ONLY! DO NOT USE ON
WAXED FLOORS!
11) When you finish cleaning, unplug the power cord from the outlet, empty the water tank,
let the appliance cool for a few minutes and carefully remove the cloth pad from the
steamer head; wind the power cord around the cord wrap and store the appliance
upright in a dry area.
CAUTION: THE CLOTH PAD MAY BE VERY HOT IF REMOVED IMMEDIATELY AFTER USE.
12) The cloth pad can be machine-washed in hot water.
INSTRUCTIONS FOR USE OF CARPET GLIDER ACCESSORY
Please ensure that the micro-fibre cloth is attached as outlined previously.
Please place the carpet glider on the floor in an upright position, with the triangular flat surface
facing downwards.
Please place the floor steamer head on the glider as illustrated.
The carpet glider is now ready for use.
IMPORTANT
The carpet glider is designed not to be fixed to the floor head without the cotton pad, for safety
reasons, including the preventing of burns.
The carpet glider is designed for use on soft carpeted areas only. It is not designed for use on
hard floor surfaces, and may damage your floor if used on hard floor surfaces.
CLEANING AND MAINTENANCE
CAUTION: PRIOR TO CLEANING OR MAINTENANCE, ISOLATE THE UNIT BY REMOVING THE CORD
FROM THE POWER SOCKET.
DO NOT IMMERSE THE UNIT IN WATER OR ANY OTHER LIQUID.