Operation Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
12 TEAM SFC 2 - 100622
Assembly page 12/40
Fax [phone]
5) Push the water tank release lock upwards to take out the water tank, unscrew the water
tank cap, fill it with cool tap water, tighten the cap, replace the water tank back to the
unit.
NOTE: Do not operate the appliance without a floor cloth in place.
6) Twist the quick release cord wrap clockwise to unwrap the power cord completely, hang
the cord on the handle cord wrap for better use of the steamer when moving and
cleaning, and plug into a grounded outlet.
7) The LED will illuminate when the steamer is plugged in.
NOTE: It is recommended that no other high wattage appliance is operated on the same
circuit to avoid a circuit overload.
8) Holding the steamer head flat on the floor, unlock it from its parking position by tilting the
steamer handle backwards.
CAUTION: WHEN USING THE STEAM CLEANER FOR THE FIRST TIME, PLEASE HOLD THE TRIGGER
PRESSED DOWN FOR APPROXIMATELY 30 SECONDS TO PRIME THE UNIT.
9) Slowly pass over the surface to be cleaned while pressing the trigger to emit steam. It is
recommended to sweep or vacuum the floor prior to using the steamer.
CAUTION: TO SANITIZE AN AREA OF YOUR FLOOR, LEAVE THE STEAMER OVER THE AREA FOR A
MINIMUM OF 8 SECONDS, BUT NO LONGER THAN 15 SECONDS. LEAVING THE
STEAMER IN A STATIONARY POSITION FOR A LONGER PERIOD THAN