Operation Manual

Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must be reproduced and folded in order to obtain a mini
booklet A5 (+/- 148.5 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don’t change the page numbering. Keep the language
integrity.
9
Assembly page 9/23
Fax [phone]

START
Touch to start the cooking or defrosting programs. The cooking indicator light and the oven
light will turn on and the cooling fan will operate.
CLOCK
Use to set the time of day or recall the time of day. The time of day will be displayed at all times
except when the oven is operating. In the event of a power failure or if the oven is unplugged,
the clock will have to be reset.
MEMORY
When programming the oven to cook by time, use the MEMORY pad when setting both the 1st
and the 2nd cooking stage. The respective lights will come on to indicate which stage the
oven is operating in.
OPERATION
BEEP DURING OVEN SETTINGS
Each time a pad is touched, a beep will sound to acknowledge the touch.
SETTING THE CLOCK
Suppose you want to enter the correct time of day6: 00(A.M or P.M).
Step: 1. Touch CLOCK pad.
2. Touch CANCEL pad.
3. Touch number pad 6 times.
4. Touch CLOCK pad again to confirm.
NOTE: This is a 12-hour clock. When the oven was plugged in, “1:01” should have
appeared in the display. To reset the time of day, repeat the steps given above. You can
check the clock time while cooking is in progress by touching the CLOCK pad.
SETTING COOKING TIMES AND POWER LEVELS
Suppose you want to cook for 5 minute at 60%.
Step: 1. Touch MICRO pad.
2. Touch number pad five times.
3. Touch POWER pad 3 times.
4. Touch START pad.
NOTE: Step 3 is not necessary for cooking at 100% power level.
PRE-SET
Suppose you want to set the oven to start-up at 2 o’clock.
Step: 1. Touch PRE-SET pad.
2. Touch number pad twice.
3. Set the cooking programs.
4. Touch START pad.
NOTE: Be sure the time of day clock is set at the correct time before programming PRE-SET.