Operation Manual

Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don’t change the page
numbering. Keep the languages integrity.
13
Assembly page 13/35
Fax [phone]

OIL
 To maintain your clipper in peak condition, the blades should be oiled every few haircuts (15).
Do not use hair oil, grease or oil mixed with kerosene or any solvent, as the solvent will
evaporate and leave the thick oil which may slow down the blades' motion.
POWER SCREW
 The power screw allows you to adjust the power. It has been adjusted before leaving the factory;
however, if the voltage in your home is low, you may need to re-adjust it. To adjust, use a
screwdriver or a thin coin to turn power screw clockwise until the arm strikes the coil, making a
noise (16). Then slowly turn power screw out (counter-clockwise) until noise stops. This is the
maximum power setting.