Operation Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
12
Assembly page 12/40
Fax [phone]
CUTTING WITHOUT THE COMB ATTACHMENT
To cut the hair with the help of a comb or your fingers as well as to cut the outlines, you do not
need the comb attachment.
 Turn the locking knob to the left to the  position.
 Take off the comb attachment by pulling it holding it by the sides. (see page 2, B 6 and 7)
Cutting hair with the help of a comb or your fingers
Remove the comb attachment carefully, as explained in the previous paragraph.
Raise a wisp of hair with the help of the comb (17), or take the wisp between your fingers (18).
Take the wisp through the comb or fingers until only the desired hair length remains under the
comb/fingers. Cut the hair that is above the comb or fingers with the hair clipper (19 and 20).
Outlining
 Outlining requires no attachments.
 Comb hair into the required style. Position clipper between the sideburns and the ear. Make
sure the outer edge of the blade is against the hairline. With the outline of the hair as your
guide, slowly move the clipper around the ears (12). For the back of the neck and the
sideburns, hold the clipper upside down (13), and move downward holding it against the
skin at the length desired.
CUTTING A BEARD
 Lead the appliance against the grain of the beard.
 Comb the beard hair with the supplied comb so that it stands as high as possible, all in the
same direction.
 Put the comb attachment on the appliance and slide it to the desired cutting setting.
 Switch on the appliance and cut the beard.
Cutting the outlines of the beard
 Remove the comb attachment from the appliance.
 Hold the appliance in diagonal position with the front side pointing away from you.
 Start with the chin and cut backwards.
 Follow the chin line and cut the longer hair at the outside of the beard.
Styling the beard
Hold the appliance vertically in front of your face, with its front side pointing away from you.
Start with the shortest areas of the beard and cut the hair directly under the beard line moving
down.
Thinning and sharpening
Take the supplied comb and bring the beard hair in the desired shape.
Hold the appliance with its front side pointing away from you and cut the hair tips by moving
down.