Operation Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
10
Assembly page 10/40
Fax [phone]
(*)
Competent qualified electrician: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp
plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour
coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
CONNECTING
 The charging base can be connected to any voltage outlet -even to shaver sockets-
between 230-240 volts ac (-).
 Place the rechargeable hair clipper, facing the front onto the charging base.
 The red charge indicator will light up, when the power unit is inserted on the plugged-in
charging base.
 The hair clipper may warm up somewhat during recharging. This has no significance on the
unit's operation. Overcharging is impossible.
 To maintain the hair clipper 's full performance, it should always be stored on the charging
base after use.
PRESERVING THE RECHARGEABLE BATTERY
To maximise the capacity and life of the rechargeable battery, it should be fully charged for 16
hours before the first use and then fully discharged by using. Then recharge to full capacity (6
hours). This discharging/charging procedure should be done every six months.
BEFORE YOU START
 Make sure that your clipper is clean, properly oiled and in perfect working condition.
Caution: if the blade is not oiled correctly, the appliance will not work properly.
 Place a towel around the neck of the person whose hair is to be cut to prevent hair from
falling inside the collar.
 Have the person sit on a chair so that his/her head is at your eye’s level.
 Comb the hair thoroughly and hold the clipper in a relaxed, comfortable grip. This will help
you maintain an accurate cutting control.
OIL (see Page 2: A)
To maintain your clipper in peak condition, the blades should be oiled every few haircuts. Do
not use hair oil, grease or oil mixed with kerosene or any solvent, as the solvent will evaporate
and leave the thick oil which may slow down the blades' motion.