Radon Pro V4.1 ESC - Manual

6. Program Card Specifications:

＊ Dimension: 91mm(L) x 53(W) x 18mm(H)

＊ Weight: ~68g

Program Card Operation:

Program Card Picture:

Step 1: Connection with Speed control:

◎Switch off the speed control power and take out the speed control BEC wire from the

receiver.

◎Connect the speed control BEC wire to the Program card connector.

Please make sure the speed control wire is connected properly based on the below description.

- Connect BEC white color wire to the program card pin at (‘S’) position.

- Connect BEC red color wire to the program card pin at (‘+’) position.

- Connect BEC black color wire to the program card pin at (‘-’) position.

◎Connect the battery to the speed control and turn on the unit. From the start, there should be a

message ‘Radon Series Program Card’. If any key pressed, LCD screen will show the firmware

version number for around 1s and then enter to Item Setting Mode