Mini-Z M-Radon V2.1 Instruction Manual

4
In setup mode, the speed control will store the neutral, forward or brake position setting inside the
built-in memory and will not lose even if it is disconnected from the battery.
Notes:
If it can’t enter to the “throttle range setting”, please try to reverse the Throttle and brake in
the transmitter setting and go to step 2 to setup the speed control again.
Step 2: cont…
◎Move the throttle stick to the full brake position, then the RED Led will be flashing until a
solid RED Led will be light up. Light up RED Led represent the full brake position has been
set.
◎Move the throttle stick back the neutral position again, then the flashing RED &
BLUE(purple color) Led will be light up that means throttle range setting has been
completed.
◎The speed control will be ready for use when it powers is off and on again.
Step 3: Double check the speed control function:
The speed control can be checked based on the below LED status.
Functions Status LED Color
Neutral BLUE
Full Throttle RED+ BLUE
Full Brake RED
◎If the above LED status is correct corresponding to the speed control function, then the
setup procedure has been completed and it is ready for using
◎If there is a mistake during the setup procedure. Please turn off the unit and repeat the
Step 2 procedure.