Mini-Z M-Radon V2.1 Instruction Manual

5. Speed Control Setup:

Step1: Transmitter Settings:

Before setup the speed control, please setup the following functions on your transmitter if

available:

Functions description Name in Radio Setting Request

Throttle Travel High ATV, EPA 100%

Brake Travel Low ATV, EPA, ATL 100%

Throttle Exponential EXP, EXPO Set at 0

Neutral Trim Sub Trim Center

Servo Reverse Throttle Reverse Any setting, keep

unchanged after the set-up

procedure

If the transmitter does not have any of the above function, it is already in basic setup

function.

Step 2: Set neutral, forward and brake endpoint data to the speed control:

◎Switch off the power of the speed control and please make sure the speed control is not

connected to the battery.

◎Remove the motor gear to allow the wheels of the model are free to rotate.

◎Switch the transmitter on and move the transmitter throttle stick to the neutral position.

◎Connect the battery to speed control and press and hold the on/off button to turn on the unit

until there is a BLUE Led light up.

◎After the BLUE Led is light up, that mean throttle range setting mode is entered and the

neutral position has been set.

◎Move the throttle to the full throttle position, then the BLUE Led will be flashing until a

solid BLUE Led will be light up. Light up BLUE Led represent the full throttle position has

been set.