Instruction manual

is moved to the forward position, the car will immediately

accelerate forward.

› Setting 1 and 2 for sensorless motors

› Setting 3 and 4 for sensor motors

2. Drag Brake Force

This parameter sets the amount of brake automatically

applied when the throttle returns to the neutral position.

This simulates the engine braking eect of a real car.

Note: some 1/8 brushless motors may have a lot of “auto-

brake” due to their construction. In that case, -1% and -2%

setting can help to reduce the auto-brake eect.

Warning! Stronger brakes will also result in higher ESC

and motor running temperature. Check the motor and ESC

temperature and adjust the parameter to keep temperature

within safe limits.

› Setting value from -2% to 10% or custom setting

3. Low Voltage Cut-o

This function helps to prevent battery over-discharge. If

the battery voltage becomes lower than the threshold for

2 seconds, the ESC power output is rst reduced and then

shut-o. When the system activates, the red LED ashes

twice repeatedly. The cuto threshold is based on this

individual cell voltage setting and the number of cells auto-

detected or adjusted by the user (setting #13).

Note: if you use a custom value, the setting is for the total

battery voltage, not single cells voltage!

Warning! A low setting can damage your battery!

› Setting value 0 (no cut-o) to 3.2V/cell or custom

setting