TBS Vendetta Manual

Installing video antenna

If you are planning to bind the receiver, it is very important that you temporarily attach the VTX antenna

before proceeding to the next step. Or you can leave it till the end of the build and attach it before connecting

the battery and setting up the receiver.

The antenna is mounted horizontally on the TBS VENDETTA to minimize shearing off the connector on

impacts and causing damage to the internal components.

1. Simply place the TBS TRIUMPH on the RP-SMA connector, twist left a little so it drops in even, then

twist right until tight. DO NOT over-tighten as you can cause damage to the connector

Binding radio receiver and system configuration

It is easier to bind and configure system at this stage in the build because the internals are all out and

accessible for troubleshooting, than when the antennas and battery strap(s) are mounted.