TBS Vendetta Manual

Setup

Getting set up and ready to fly is a quick and simple task, as mostly everything comes pre-built from the TBS

factory. When using TBS equipment, it is mostly plug & play to get ready. Follow these easy steps and you will

be shredding the sky in just a few minutes!

Opening the frame

The insides are protected by a very strong carbon fiber body. By removing the front canopy, all the internals

easily slide out.

1. On the front of the frame, remove the two M2x9 hex screws and plastic caps on both sides to loosen

the plastic camera canopy

2. Remove the canopy and with a slight push from behind, the internals should slide out