TBS Vendetta Manual

Flight modes
With no flight mode switch, the default is ACRO-mode. If you are a beginner, it is recommended to add a two.
or three-position switch to toggle between ANGLE/HORIZON/ACRO-mode.
1. Open CleanFlight and go to the “Modes”-tab
2. Now, select an AUX-switch from the dropdown menu, these linked to the channel (listed in
“Receiver”)
3. For ACRO-mode, move the end-points between 900 and 1300, and for HORIZON-mode, move the
end-points between 1300 and 1700, click “Save”
Finally, try to power up the VENDETTA and radio, and toggle the flight mode-switch, the small marker
underneath the range should move and the label on the left will turn green when you change to ACRO or
HORIZON.
Lost alarm
In an event you should lose the quad in a large grassy field or obstructed area, a lost alarm beeper can come
in handy. By default the beeper is not set up. The easiest way to engage the beeper is to use a free
toggle-switch on the radio.
1. Configure the radio to send the toggle switch on an empty channel, f.ex. ch6
2. Power up VENDETTA and connect to the micro-USB interface
3. Open CleanFlight/BetaFlight, hit “Connect”, and go to the “Receiver”-tab
4. Toggle the switch back and forth to verify that the channel is mapped correctly, make a note of which
AUX number
5. Move over to the “Modes”-tab and scroll down to “BEEPER”, from the drop-down menu pick the AUX
number to link the beeper, hit “Save”
6. Try toggling the switch to engage the beeper, make adjustment to the active range by moving the
slider end-points
27