TBS Vendetta Manual

Receiver setup

If you upgrade the COLIBRI firmware or reset settings, you will lose the connection between the COLIBRI and

receiver.

To setup the connection via CleanFlight or BetaFlight:

1. Open CleanFlight/BetaFlight and hit “Connect”

2. Go to the “Ports”-tab and enable “Serial RX” for UART2, hit “Save and Reboot”

3. Move over to the “Configuration”-tab and change “Receiver Mode” to “RX_SERIAL” and “Serial Receiver

Provider” to “SBUS” - or the protocol used by your particular receiver, hit “Save and Reboot”

4. Now, power up the VENDETTA (to power the receiver) and go to the “Receiver”-tab, the stick

movements should now show on the screen - if the channel mapping is wrong, either fix this on the

radio side or change the “Channel Map” field to the right order, click “Save and Continue”