TBS Vendetta Manual

○ OSD Type - Vendetta/CORE PRO -

○ Factory Reset - Reset all CORE PRO settings to default

● Artificial Horizon - Uses the gyro and accelerometer to estimate level plane

○ Show Horizon - Off/Basic - Shows a line in the middle of the display to indicate level position

● Callsign - Personal HAM licence number

○ Show Callsign - Minutely/Always/Off - Display the HAM callsign and mm:ss timer on the

lower-left corner

○ Enter Callsign - 0 to 10 characters - Enter your callsign, defaults to “TBS”

Flight Controller

● PID - Detailed Proportional–Integral–Derivative controller values for Roll, Pitch and Yaw

● Rate - Stick sensitivity multiplier values

● Settings - Looptime and Idle Motors settings

● Calibration - RC/Radio Calibration wizard for setting up the receiver or this can also be done in

CleanFlight and the data read back to the CORE PRO. Run the accelerometer calibration on a leveled

surface

● Filters - Advanced setup of Gyro and PD Cut Frequency settings

Video Transmitter

● VTX Unlock - Brings you to Callsign settings to change the id from the default “TBS”

● Band - A/B/Race/E/Airwave/User - Video transmitter frequency band

● Channel - 1 to 8 - Channel number (frequency) within the selected band

● Power Level - 25/200/500/800mW - Transmitter output power level

● VTX LED Strip - Changes color depending on the channel used