TBS Vendetta Manual

Attaching frame arms

The arms for the TBS VENDETTA easily installs on the bottom of the frame, motors already installed. As the

arms are identical, either one can be installed in the front or back slots - they will only install in one direction,

there is no way to make any erroneous installs.

1. Position the arms with the curved arms facing away from the center, align the arms with the MT30

connectors, making sure they line up perfectly

2. Place a thumb on each side of arm under the connector and push firmly until they flush with the

body

3. Use four M3x9 hex screws to secure each arm to the body - they have threadlock pre-applied from

the factory