TBS Vendetta Manual
Pairing the radio and receiver is covered in the manufacturer's instructions.
The initial setup of the COLIBRI and CORE requires the FPV video feed to be up on channel Band A CH1 5865
MHz. All the configuration is done via the R/C radio sticks as prompted on the OSD screen.
In order to make the VENDETTA recognize the type of the R/C signal (SBUS, PPM, SPEK), the COLIBRI has to be
set up with the correct protocol. This is done by pressing the “ENTER”-button on the CORE PRO, as shown in
the picture below - if the protocol is anything other than the default PPM.
Adjusting camera tilt angle
The angle of the FPV pilot camera can be adjusted between 15 to 30 by untightening the set screws behind°
the camera and setting the preferred angle, then tightening the screw back. A 15 tilt is recommended for°
beginner flyers and higher for fast forward flight and more advanced pilots.
1. Use a hex screwdriver to loosen the two M2.5x8 set screws on either side of the camera mount
2. Adjust the angle to the desired position and retighten the screws, make sure to straightening the
camera by looking from from the front - it is also possible to adjust the angle through pre-cut slots
after the build is done
10