TBS Unify Pro HV 5.8GHZ VTX
Button Menu
There are categories in the menu, and settings. Pressing the button for 3 seconds will toggle between
categories, pressing it for a short time toggles between settings. To enter the menu, hold the button for 3
seconds. LED colors will signal the state of the menu, for an overview see the table below.
Channel select mode
Enter menu by pressing the button for 3s. Red LED will flash 1x. Select channels.
Band select mode
Press button for an additional 3s. Red LED will flash 2x. Select band.
Unlock & power select mode
FOR HAM USERS ONLY! Press button for 20 - 25 seconds. The Red LED will flash 3x to confirm. You have
unlocked the video transmitter for use with all frequencies (see frequency table below). The power select
mode is now accessible. Once unlocked, you can select the power level according to the table below. To lock
the transmitter, go back into band select menu and press the button for 20s-25s again.
PitMode
While in PitMode you can change channels and set power levels with the button, but none of these changes
will take effect until next power cycle. By default, PitMode will send a very weak signal on 5584MHz when the
VTx is unlocked, or transmit nothing at all when locked. The signal on 5584MHz is barely enough for you to
adjust parameters or test functionality of the quad - it is NOT meant for FPV flying! New receivers such as the
TBS Tango will provide support for this channel.
Save and exit
Press button for an 3s. Blue LED will turn on, settings are saved and will exit the menu.
3