TBS Tracer Manual



Getting ready
Getting set up and ready to fly is a quick and simple task. In most cases plug&play when using TBS
equipment. To bind, place your Tracer Micro or Nano TX into bind mode by pushing the button on the back
of the device, then connect power to your receiver. It will enter bind mode automatically the first time. If
you see a blue LED, please push the button once to confirm the start of the OTA firmware update and wait
about 1 minute. When bind is complete, the LED on the back of the Tracer transmitter will indicate green.
FAQ
If you got any question after reading this manual you should visit the TBS FAQ section
Note
This manual is written based on  Tracer FW 4.35 . There may be minor variations depending on the version
that is available at this moment.
Updating
In order to update and configure your Tracer, you need the TBS Agent X, which you can download from the
TBS shop.
To update your Tracer, connect it by USB and run the update by Agent X. The receiver will automatically get
the update on the next bind (more information in the receiver update section)
For detailed instructions on how to use the Agent X, have a look at the Agent X manual.


 


8
