TBS Tracer Manual




If you use MAVLink, you can also use the RC over MAVlink  option to save the extra wiring. The details can
be found in this section.
If you use the PX4 firmware, you don’t need to configure the telemetry port to get it running.
Wireless configuration with ArduPilot/ PX4 by WiFi
Over the built-in WiFi module you can get MAVLink data to your pc or mobile device for live telemetry as
well as full MAVLink data transmission (as with the bluetooth module).
You need to set up your wifi module for that to work before.
You can connect to your Tracer in two ways:
● Both are in the same WiFi network
● Straight connection to the Tracer access point
When you are connected, you need to use the following settings:
● Connection type: UDP
● Port: 8888
The port can be changed in the settings of the WiFI module, if you need to.
 


43
