TBS Tracer Manual



the VTx to CRSF or SA, you can unsolder the wire or force your Tracer rx to not output any signal.
● Set the output of the Tracer Rx to CH X (PWM) for the pin where the VTx is connected to
● Shut down the Tracer Tx and Rx
● Power up just the drone with the Tracer Rx and the Unify32
● Change the Unify32 settings by the button
● Turn the transmitter back on
● Set the output map back to CRSF or SmartAudio
Connection to an FC
General wiring

If you use SBus or any other protocol beside CRSF or MAVLink, you only need to connect the receivers Tx
line to your FC. Use CRSF whenever possible to get the best experience with your Tracer.


If you use a F4 FC, make sure you don’t use UART’s
with labels with  SBUS  or  S-PORT . Those UART’s got
a hardware-inverter installed which does not work
with CRSF.
 


39
