Team Black Sheep Crossfire RC System - Manual

CLI commands
Rf mode dynamic or forced 50Hz:
set osd_link_quality_alarm = 70
set osd_RSSI_dbm_alarm = -100
Rf mode forced 150Hz:
set osd_link_quality_alarm = 40
set osd_RSSI_dbm_alarm = -100
Signal strength in iNav - iNav < 3.xx
In iNav, it’s almost the same as with the old BetaFlight method, except that you don’t need to assign LQ to
a channel in the channel map menu.
iNav reads the LQ from the CRSF stream and outputs it automatically on Channel 17 (from iNav).
Signal strength in iNav - iNav 3.xx and later
With iNav 3 the LQ readout can be set up the same way as for BF 4.1 and later. The CLI commands are not
necessary.
Link States
LQ
Link quality
The number of packages that arrive correctly. If the number starts to drop, more packages are lost.
In the TBS OSD’s the LQ is scaled from 0-300%:
● 0-100%: 50/4 Hz mode
● 170-300%: 150Hz mode
If you use LQ as a sensor by the channel/ output map menu or as an OpenTX telemetry sensor, it behaves
like this:
● 150Hz mode: 100%
● 50/4Hz mode: 0-100%
76