Team Black Sheep Crossfire RC System - Manual

Using CRSF will give you the lowest possible latency from your stick to the drone and full telemetry back to
your radio.
LQ warning in OpenTX
The setup for the radio is relay simple:
What they mean:
L01: Monitors the CROSSFIRE frequency mode, activated when it's not in 150Hz mode
L02: Active when the Link quality drops below 80% (pre-warning) AND 50 or 4 Hz mode is active
L03: Same as L02 but with the critical warning level at 70%
L02 and L03 also got a small delay (0.5s) to avoid warnings when the signal is only bad for a short moment.
Note: since CROSSFIRE FW 2.93, the RFMD no longer needs to be compared as the LQ sensor will stay at
100% while in 150Hz mode (RFMD = 2)
When you use the 150Hz locked mode of the CROSSFIRE, the levels are 40% for L02 and 30% for L03
58