Team Black Sheep Crossfire RC System - Manual

Missing sensors
If you got issues finding sensors or only a few appear, make sure you disabled Ignore Instances in the
telemetry settings page of your radio
In-built Voltage monitoring
The CROSSFIRE receivers are capable of measuring the voltage of their power supply. This becomes handy
when you use an RC glider where space matters.
This feature works on up to a 2s LiPo (max. Operation voltage for all receivers!) for almost all receivers,
except for the Nano RX rev 43 and lower.
If you experience issues with another voltage sensor in your system, you can disable the CROSSFIRE sensor
in the settings under
Receiver/General - Voltage Sensor
BST connection
BST (Blacksheep telemetry) is a bus system used by TBS to connect your gear like the TBS GPS puck, CORE
PRO, etc. All devices are connected in parallel. The BST bus needs to get clean 5v to power up the
connected devices:
Power type:
BST 5V
VBATT
BEC 5V
FC 5V
TBS CROSSFIRE
✔ PWR IN
✔ PWR IN
TBS BLACKBOX (discontinued)
✔ PWR IN
✔ PWR IN
TBS GPS
✔ PWR IN
TBS CORE PRO / FPVISION
✔ PWR OUT
✔ PWR IN
TBS CURRENT SENSOR
✔ PWR IN
✔ PWR
OUT
53