Team Black Sheep Crossfire RC System - Manual

Head-tracking

The standard TBS CROSSFIRE transmitter supports standard head-tracking input via the right 3-pin HT port.

Solder the included pigtail cable to suit your particular head-tracking setup. Only a two-wire connection

between TBS CROSSFIRE and the head-tracker is required. The PPM feed from the head-tracker needs to

be connected to the PPM pin of the PPM pin and ground needs to be connected to ground of the 3-pin

PPM cable.

The status display will indicate if the signal has been recognized properly. Inside the menu under

Headtracker

, three functions for pan, tilt, and roll are freely mappable. Each function has a source and

destination selection. The selected channel under source will replace the channel selected under

destination. This gives you the ability to map your head tracker channels from any channel of the

Headtracker

input to the RC link frame.

Src. Ch. XX: the channel number where the signal for this axis is incoming.