Team Black Sheep Crossfire RC System - Manual

Note: Forced Telemetry is not meant to be used in normal conditions. The best practice is to not use it.
Transmitter LED status indicator
The RGB LED on the transmitter gives you at any moment an indication of your link status.
Transmitter LED sequence
Description
Pulsing
Ready, trying to connect to a receiver or no down-link established
Green ▀▀▀
Solid link, 150Hz or 50Hz link mode active
Blue ▀▀▀
OTA Update of the receiver is running
Slow blue blinking ■ ■ ■ ■
Update confirmation required
Fast green flashing ■ ■ ■ ■
Transmitter bootloader active
Fast red flashing ■ ■ ■ ■
Warning, a message is shown on the OLED display/ LUA Script
Purple ▀▀▀
Find-mode engaged (Standard/ Lite TX only)
Blue ▀▀▀
Race mode active (150Hz locked, 25mw), if no update is running!
Teal ▀▀▀
Race mode active (150Hz locked, 100mw)
Receiver LED status indicator
There are three (Standard diversity RX) or two (any other receiver) LEDs on the receiver giving you an
indication of link- and backup-battery status.
Receiver LED indicators
Description
Solid green ▀▀▀
The link is up and running OK
Solid red ▀▀▀
No packages received from the transmitter and receiver is in
failsafe mode
Slow red blinking ▀ ▀ ▀
The receiver needs an update, confirmation on the TX is required
Slow green blinking ▀ ▀ ▀
The receiver is in binding mode/ Find mode active (div. RX only)
Fast green blinking ■ ■ ■ ■
Receiver bootloader active or firmware upgrade running
Green is flashing █ █ █
diversity RX is in Find-mode (up to 1 min. delay between flashing)
Double green blinking ■ ■ ■ ■
Authentication running/ error. Rebind your receiver if it remains
longer than a few seconds -
more details
Red/ Green blinking, any
pattern
■ ■ ■ ■
firmware issue, run the emergency update for the receiver, then
rebind it
Find mode is only available with the diversity receivers.
35