Team Black Sheep Crossfire RC System - Manual

Dynamic transmission power
The system can automatically choose the power level most suitable for the situation at hand. For instance,
if you fly close to the transmitter you normally only require minimal TX power and the system will
therefore switch to the lowest possible TX power level required to maintain a good up-link.
The maximum TX power level the system is allowed to use can be defined by changing “Max Power” in the
configuration menu.
RF power switch
Since FW 6.03 you can select the max. Rf power level by a 2/3 position switch.
How does “Power Switch” work:
- Dynamic Off: the output power is the setup up the power on the switch position
- Dynamic On: the max. output power the CROSSFIRE can use is the setup up power on the switch
position
The power level selected by the switch acts the same way as when the
max power setting got changed.
Operating modes
Operation mode is where you can set the CROSSFIRE in an ultra-low update rate, high range mode.
Normally the CROSSFIRE switches from 150Hz to 50Hz, depending on the link quality. With
Forced
Telemetry
enabled, it will now only switch between 50Hz and 4Hz mode. Only enable it if you know what
you are doing.
34