Team Black Sheep Crossfire RC System - Manual

Standard/ Lite TX shortcut

For these two transmitters you can run a shortcut to set the failsafe position:

- Set the sticks and switches, in the position you want them

- Push the joystick down

- Push and hold it up for a few seconds

Failsafe Set

will appear

Failsafe test

When you have set up or changed the failsafe behavior, it’s important to test the correct function on the

ground. To test it:

1. Remove the propeller of your aircraft

2. Power up the radio and the model

3. Arm the model (with FC) or move your sticks into a certain position (no FC)

4. Shut down your radio

5. Depending on the failsafe type and model, check if the behavior is correct