Team Black Sheep Crossfire RC System - Manual

Real-world example
The most common combination is that you already own a CROSSFIRE transmitter to which all your
receivers are bound and now you have a second transmitter like the TANGO 2. Here is how you get them
both running with Multi-bind, assuming that you already got your user id on both transmitters:
1. Make sure both radios got the same firmware version
2. Power up your “old” transmitter and make sure Multi-bind is turned off for now
3. Power up the receiver - if you updated this transmitter, run the OTA update by the auto-bind
feature
4. Turn Multi-bind on - the link will break up for 1or 2 seconds and will be regained then
5. Shut down the receiver
6. Turn Multi-bind off in your “old” transmitter
7. Power up the next receiver
8. Repeat step 4 till all your receivers are switched to Multi-bind
9. When the last receiver is set to Multi-bind, let it enabled in your “old” transmitter
10. Start your new Transmitter
11. Turn Multi-bind on
12. Power up a receiver - your new transmitter will bind to your receiver as the old transmitter did
If the switching fails, you can turn on Multi-bind on your transmitter and then bind the receiver with the
Bind button (classic binding).
28