Team Black Sheep Crossfire RC System - Manual

Binding
● If you’ve got a bound receiver, just bind/ update it with Multi-bind turned off, and while it’s
connected turn Multi-bind on. Wait for a few seconds, then the link will come back again.
● On a new receiver, you can just bind it by the button as usual.
● On the other CROSSFIRE TX, just enable “Multi-bind”. When the first TX is shut down, you can
power up the second transmitter. It should bind to this receiver within a few seconds.
Disable Multi-bind
● To disable the Multi-bind option you just need to set the “
Multi-bind ” option to “disable”. If the link
is running, just switch it off and wait a moment till the link regains.
● Otherwise, rebind the receiver by the button.
Wrong ID/new ID
● You may need a “new” id. To get a new ID, simply connect your CROSSFIRE to Agent X with the
new/correct user account and let it synchronize with the TBS CLOUD.
● The next time the WiFi module connects to the internet it will get the new id after a few seconds.
General note:
Model match affects Multi-bind behavior. If the model ID is not the 00 in both radios, devices will not bind.
If model-match is not enabled on a receiver, it will assume model ID “00”.
27