Team Black Sheep Crossfire RC System - Manual

RC input Signals

Depending on the remote and firmware you use, there are different input protocols available:

● PPM

● CRSF V1/ 2/ 3/ CRSFShot

In Agent X/ M/ Lite the detected signal can be found under

Transmitter/ About/ RC Input

PPM

PPM should only be used with radios not supporting CRSF. It got a high latency and no telemetry

CRSF V1/ 2

CRSF enabled telemetry since version 2 and runs with low latency.

CRSF V2s

The

indicates that the lower communication speed has been enabled in the radio. Details can be found in

the mod section.

CRSFShot

CRSFShot is CRSF V2, including the synchronization between the radio and the transmitter to eliminate the

variable latency. This results in a mode locked-in feeling with your drone.

CRSF V3

CRSF V3 is the latest revision of the CRSF protocol. It includes CRSFShot and reduces the latency between

the radio and the transmitter even more. CRSF V3 was introduced with CROSSFIRE FW 6.03.

CRSF V3*

The

indicates a full-speed connection. As CRSF V3 raised the speed, even more radios require the

hardware mod.