Team Black Sheep Crossfire RC System - Manual

JR-bay issue

When you have set up everything properly in OpenTX but your module still stays off, the radio pins did not

slide into the CROSSFIRE TX. In this case, you can bend all the pins in the JR bay just a little bit to the right

or left side and plug the module bag in.

Other radios

If you own a radio without a JR-bay, you need to use the Standard/ Lite transmitter with their input pins

for many trainer-port connectors, which you then connect to the RC In plug.

Note: by this connection, you can not use CRSF between your radio and the CROSSFIRE TX. If your radio

supports CRSF, you need to feed the signal wire in the plug on the right. Check the TX

pinout for details.

Hitec/Graupner/JR-cable