ASC90040C Team Associated Reflex-DB10 Manual

17
:: Shocks Build - Step 3
:: Shocks Build - Step 4
:: Shocks Build - Step 2
Front Shock: 30wt
Rear Shock: 30wt
Step 9-10
Stroke
Front: 26.0mm
Rear: 35mm
Free Length
Front: 86.25mm
Rear: 103.50mm
Free
Length
Stroke
Stroke
Step 1-3 Step 3-4 Step 5-6 Step 7
Shock Bleeding Steps:
1. Pull shock shaft down.
2. Fill shock body 3/4 full with silicone
fluid.
3. Slowly move the shock shaft up and
down to remove air from under piston.
4. Wait for bubbles to come to surface.
5. Fill shock body to top with silicone fluid.
6. Place a drop of oil in the cap and on
cap threads.
7. Install cap and tighten completely.
8. Slowly compress shaft all the way to
the top. If there is pressure at the top
of the stroke, there is too much oil or
air. You must bleed it out.
9. Slowly pull shaft out.
10. Unscrew the cap 3/4 turn and tilt the
shock at a slight angle.
11. Slowly compress the shaft to push
out excess oil and air. You should see
bubbles coming out from under the
cap.
12. With the shaft compressed, tighten
the cap and re-check for pressure at
the top of the stroke. If there is still
pressure, repeat steps 9 thru11.
Shock fluid
#5422
Shock fluid
#5422
91454
Shock Cap
(Molded)
Front
Shocks
Rear
Shocks
Pre-Load
Spacers
1mm
2mm
3mm
5mm
91636
12mm front
spring (54mm),
White (4.10lb)
91639
12mm rear
spring (72mm),
Green (2.20lb)
Build x2 front and x2 rear shocks
#1105
green slime
#1105
green slime
Racers Tip:
Coating the o-rings
with green slime
(#1105) helps seal
& reduce o-ring
swell! Green slime
not included in kit!
91469
Shock
eyelet
91469
Shock
Pivot Ball
71051
Shock Body
12 x 27.5mm
(front)
71052
Shock Body
12 x 36mm
(rear)
91444
Shock
Internals
5407
O-Ring
91454
Shock
Bottom Cap
91491
Shock
Bottom Cap
O-Ring
91454
Shock Cap
O-Ring
x2
Lightly rub shock oil
on the o-ring before
installation!
!
71054
Pre Load
Spacers
91454
Spring
Cup
71054
Spring
Collar