User Manual

12
:: Suspension Arms Build - Bag 8, 9, 10, & 11 - Step 6
:: Suspension Arms Build - Bag 8, 9, 10, & 11 - Step 7
:: Suspension Arms Build - Bag 8, 9, 10, & 11 - Step 8
Droop:
The standard settings of 6mm front and
5mm rear will work best in most cases.
Droop is measured just underneath the
outer hinge pin as shown in the photos
to the right.
On bumpy or low grip
surfaces, increase the droop (going to a
lower number on the droop gauge), this
will help increase traction and consistency.
Droop adjustments of 0.5mm to 1mm can
be very effective on the track!
Arm Mount Inserts
Negative to the inside of vehicle.
Positive to the outside of vehicle.
1 DOT
0 °
-2 DOT
-1/2 °
+2 DOT
+1/2 °
-1 °
-3 DOT
+3 DOT
+1 °
x2
31541
M3x6mm
fhcs
x2
4617
Bulkhead
shim
(0.5mm)
x2
x2
31541
M3x6mm
fhcs
4617
Bulkhead
shim
(0.5mm)
Rear Droop
Setting: 5mm
1
0
2
3
4
5
6
7
8
1
0
2
3
4
5
6
7
8
Front Droop
Setting: 6mm
x2
31620
TC6.2 arm
mount insert ,
rear
(1 dot, 0°)
31618
TC6.2
Outer Arm
Mount
Rear
outer arm
mounts
Rear of
chassis
!