User Manual

22
:: Notes
31
28
24
23
22
21
20
Pinion
78
78
81
81
81
81
81
Spur
6.21:1
6.88:1
8.33:1
8.69:1
9.09:1
9.52:1
10.00:1
Final Drive Ratio
17.5 Reedy Sonic Brushless
13.5 Reedy Sonic Brushless
10.5 Reedy Sonic Brushless
9.5 Reedy Sonic Brushless
8.5 Reedy Sonic Brushless
7.5 Reedy Sonic Brushless
6.5 Reedy Sonic Brushless
Motor
B64 Gear Ratio Chart (Internal Gear Ratio 2.47:1)
Motor Gearing:
Proper motor gearing will result in maximum performance and run time while reducing the chance of overheating and
premature motor failure. The gear ratio chart lists recommended starting gear ratios for the most widely used
motor types. Gear ratios will vary depending upon motor brand, wind, and electronic speed control. Consult your
motor and electronic speed control manufacturers for more information.
Team Associated is not responsible for motor damage due to improper gearing.
Set The Gear Mesh:
You should be able to rock the spur gear back
and forth in the teeth of the pinion gear without
making the pinion gear move. If the spur gear
mesh is tight, then loosen the #25211 screws
and move the motor away, then try again.
A gear mesh that is too tight or too loose will
reduce power and damage the gear teeth.
:: Optional Slipper
9651
31500
91176
91197
91198
91563
92090
92091
92092
92093
1
10
1
2
2
2
1
1
1
1
Spur Gear, 48P, 81T
3x2.5mm Set Screw
VTS Slipper Housing
LCF Slipper Pad
LCF VTS Slipper Pad
10x15x4mm Bearing
B64 Slipper Hub
B64 Slipper Basket Disc / Hub
Slipper Outdrive / Shaft Outdrive
Slipper Spring and Nut
31500
92092
92093
9651
91176
91198
91198
92091
92091
91197
92090
91563
91563
92093
92092
31500
:: Electronics/Wheels & Tires/Body & Wing Build - Bag 13.1, 13.2, 13.3 - Step 6
Painting Tips:
Your B64 comes with a clear polycarbonate
body. You will need to prep the body before you
can paint it. Wash the inside thoroughly with
warm water and liquid detergent. Dry the body
using a clean, soft, lint-free cloth. Use the sup-
plied window masks to cover the windows from
the INSIDE of the body (RC cars get painted
from the inside).
Using high quality masking tape, apply tape to
the inside of the body to create a design. Spray
(either rattle can or airbrush) the paint to the
inside of the body (prefferably dark colors first,
lighter colors last).
NOTE: use ONLY paint that is recommended
for use with (polycarbonate) plastics. If you
don’t, you can destroy the plastic body!!!!).
After painting, cut the body along the trim lines.
Make sure to drill or use a body reamer to make
the holes for the body mounts and antenna!
Wing Mount Shim
Front of Vehicle
0° - Mount
under wing
3° - Mount
above wing
6° - Mount
under wing
25202
3x10mm
FHCS
x2
x2
92050
B64 Wing
Mount Shim
91741
B6 Wing
92050
B64 Wing
Buttons