User Manual

19
:: Shocks Build - Bag 12.1, 12.2, 12.3 - Step 5
B A
B
A
25612
M3 Locknut
w/Flange
25612
M3 Locknut
w/Flange
91447
Shock
Bushing
91447
Shock
Bushing
89203
3x16mm
BHCS
25187
3x14mm
BHCS
:: Shocks Build - Bag 12.1, 12.2, 12.3 - Step 4
91304
12mm
Threaded
Collar
91491
12mm
threaded
collar
o-ring
x4
x4
collar
o-ring
91310
12mm Shock
Spring Cup
Front:
(5mm offset)
Rear:
(0mm offset)
91331
12mm Front
Spring, Yellow
(3.75lb)
91336
12mm Rear
Spring, Green
(2.00lb)
Build x2 front and x2 rear shocks
Racers Tip:
Use your finger to rub
shock oil on the o-ring for
smoother adjustment!
#91310 12mm Shock Spring Cups
0mm 5mm 9mm
Front:
8.25mm
Rear:
6.00mm
:: Shocks Build - Bag 12.1, 12.2, 12.3 - Step 3
Front Shock: 37.5 wt
#5433
Rear Shock: 30 wt
#5422
Shock fluid
Steps 9-10Step 8Steps 6-7Steps 4-5Steps 2-3
Shock Bleeding Steps:
1. Before assembly, install each bleed
screw 1-2 turns into the shock cap,
then remove the screw. This will
make it easier when you are bleed-
ing your shocks.
2. Pull shock shaft down.
3. Fill shock body 3/4 full with silicone
shock fluid.
4. Slowly move the shock shaft up and
down to remove air from under the
piston.
5. Wait for bubbles to come to sur-
face.
6. Fill shock body to top with silicone
shock fluid.
7. Place a drop of oil in the cap and on
cap threads.
8. Install cap (without bleed screw)
and tighten completely.
9. Slowly compress shaft all the way
to bleed excess silicone shock fluid
out the hole in the cap (use rag
around shock to catch excess fluid).
10. Install M2x4mm button head
screw until snug while shaft is fully
compressed.
Stroke
Front: 22.00mm
Rear: 28.5mm
Stroke
Stroke
Shock fluid
91492
M2 x 4mm
BHCS
91449
12mm
Shock Cap