User Manual

4
:: Table of Contents
:: Notes
1....................Cover
2....................Introduction
3....................1:1 Hardware “Fold Out”
4....................Table of Contents
5 - 6..............Differential / Clutch Build
(Bag 1.1, 1.2, 1.3)
6...................Chassis Build
(Bag 2.1, 2.2)
7....................Center Bulkhead Build
(Bag 3.1, 3.2, 3.3)
7....................Steering Rack Build
(Bag 4.1, 4.2)
8 - 9.............Front Gearbox Build
(Bag 5.1, 5.2)
10 - 11........Steering Block Build
(Bag 6.1, 6.2)
11.................Servo Build
(Bag 7.1, 7.2)
12 - 13........Rear Gearbox Build
(Bag 8.1, 8.2)
14.................Rear Hub Build
(Bag 9.1, 9.2)
15 - 16........Anti Roll Bars Build
(Bag 10.1, 10.2)
16 - 17........Turnbuckle Build
(Bag 11.1)
17 - 19........Shocks Build
(Bag 12.1, 12.2, 12.3)
19 - 21........Electronics, Wheel & Tire,
Wing & Body Install
(Bag 13.1, 13.2, 13.3)
21 - 22........Notes
23 - 31........Catalog
32.................Setup Sheet “Kit Setup”
33.................Setup Sheet “Blank”
34.................Back Cover
Associated Electrics, Inc.
26021 Commercentre Dr.
Lake Forest, CA 92630
http://www.TeamAssociated.com · http://www.RC10.com · http://twitter.com/Team_Associated · http://bit.ly/AEonFacebook
Customer Service
Tel: [phone]
Fax: [phone]
There is a 1:1 hardware foldout page in the
front of the manual. To check the size of a part,
line up your hardare with the correct drawing
until you find the exact size. Each part in the
foldout has a number assigned to it for ordering
replacement parts.
This symbol indicates a special
note or instruction in the manual.
This symbol indicates a Racers Tip.
!