User Manual

:: Shocks Build - Bag 12.1, 12.2, 12.3 - Step 4
18
:: Shocks Build - Bag 12.1, 12.2, 12.3 - Step 3
:: Shocks Build - Bag 12.1, 12.2, 12.3 - Step 2
91304
12mm
threaded
collar
91491
12mm
threaded
collar
o-ring
x4
x4
collar
o-ring
91310
12mm shock
spring cup
Front:
(5mm offset)
Rear:
(0mm offset)
91334
12mm front
spring, Purple
(4.20lb)
91338
12mm rear
spring, Gray
(2.20lb)
Build x2 front and x2 rear shocks
Racers Tip:
Use your finger to rub
shock oil on the o-ring for
smoother adjustment!
#91310 12mm Shock Spring Cups
0mm 5mm 9mm
Front Shock: 37.5 wt
#5433
Rear Shock: 27.5 wt
#5426
Shock fluid
Steps 9-10Step 8Steps 6-7Steps 4-5Steps 2-3
Shock Bleeding Steps:
1. Before assembly, install each bleed
screw 1-2 turns into the shock cap,
then remove the screw. This will
make it easier when you are bleed-
ing your shocks.
2. Pull shock shaft down.
3. Fill shock body 3/4 full with silicone
shock fluid.
4. Slowly move the shock shaft up and
down to remove air from under the
piston.
5. Wait for bubbles to come to sur-
face.
6. Fill shock body to top with silicone
shock fluid.
7. Place a drop of oil in the cap and on
cap threads.
8. Install cap (without bleed screw)
and tighten completely.
9. Slowly compress shaft all the way
to bleed excess silicone shock fluid
out the hole in the cap (use rag
around shock to catch excess fluid).
10. Install M2x4mm button head
screw until snug while shaft is fully
compressed.
Rear Shock: 27.5 wt
Rear Shock: 27.5 wt
Stroke
Front: 21.00mm
Rear: 27.5mm
Stroke
Stroke
Shock fluid
91492
M2 x 4mm
BHCS
91449
12mm
Shock Cap
91480
12x23mm V2
Shock Bodies
(front)
91481
12x27.5mm
V2 Shock
Bodies (rear)
91495
V2 Shock
Hat Bushing
91495
V2 Shock
Spacer
91493
X-Ring
31327
VCS3 Shock
Bottom Cap
31327
VCS3 Shock
Bottom Cap
O-Ring
91491
12mm
Shock Cap
O-Ring
x2
x2
#1105
green slime
Lightly rub shock oil
on the o-ring before
installation!
There is a short and
long shock eyelet.
Front shocks use
the long eyelet, rear
shocks use the long
eyelet.
Racers Tip:
Coating the X-rings
with green slime
(#1105) helps seal
& reduce o-ring
swell! Green slime
not included in kit!
!
!
#1105
green slime
the long eyelet, rear
shocks use the long
91721
Shock Eyelet
Front Shocks - Long
Rear Shocks - Long
91721
Shock
Pivot Ball
Short / Long
Front:
8.25mm
Rear:
6.00mm